mangOH Red Getting Started page 31

Rev 2 8/23/17
6. Check the connection status:
# cm data
a. If "Connected" is:
· "no", and APN has a value—The mangOH Red is ready to connect to the
network. Go to
· "no", and APN is blank—You must set the APN. Continue to the next step
(step b).
· "yes"—The mangOH Red is connected to the network. Go to
b. If you need to set the APN, replace "<your apn>" with the actual APN in the
following command:
# cm data apn <your_apn>
Note: The APN for the Sierra Wireless SIM is internet.sierrawireless.com.
Note: If your mobile network operator uses different APNs for 3G and LTE, make sure
to use the APN for the correct network based on your CF3 module type. For example,
the WP8548 is a 3G-only module that does not support LTE—the APN for the network
operator's 3G network should be used.
31
Example response when
Not connected, APN is set
Example response when
Not connected, no APN
Example response when
Connected
Step 7.
Step 8.
41110481