mangOH Red Getting Started page 14

mangOH Red Getting Started
Rev 2 8/23/17
Note: The USB serial port enumerates as ttyUSB0 because you connected
CONSOLE USB to the host before connecting CF3 USB to the host (which you will do
later). However, if you connected CF3 USB first, it would enumerate ttyUSB0,
ttyUSB1, and ttyUSB2. Then when CONSOLE USB is connected, it will enumerate as
ttyUSB3.
Note: You can exit minicom at any time—the purpose of showing it here is to demon-
strate how to display console messages for debugging purposes. To exit minicom,
press Ctrl+A, then press X. When prompted, select Yes to leave minicom.
Note: Through the rest of this guide, examples use terminal windows connected via ssh,
but a console connection could also be used. However, only one console connection can
be opened at any time since it locks the USB serial port.
11. Power up the mangOH Red:
a. Use a micro-USB cable to connect the CF3 USB connector to a USB port on
the dev machine.
14
CF3 USB connector
(bottom side of board)
41110481