mangOH Red Getting Started page 33

Rev 2 8/23/17
b. Stop the ping command when responses begin to appear—Press Ctrl+C to
return to the command prompt.
Note: If no responses appear within 30 seconds, press Ctrl+C, make sure the
antenna is connected, and go back to
response, power cycle the mangOH_Red and start the procedure again.
9. Now that you know how to start a data connection, you will be able to transmit
data to the IoT cloud. (In the next section, you will set up your free account on the
Sierra Wireless AirVantage IoT Acceleration Platform.)
For now, enter the disconnect command to close the data connection while you
set up your AirVantage account:
# cm data connect -1
Now that you know how to start (open) and stop (close) a data connection, you are
ready to Connect to the IoT Cloud on page 34
33
Step 4 and try again. If you still cannot get a
and begin sending data to the 'cloud'.
41110481