Table of Contents
Advertisement
8. "Insert filter in housing and push down fully" (fig. 63). Press
"Next";
9. "Insert water tank" (fig. 6): close the tank with the lid
(A24), then put the tank back in the machine and close the
front door. Press "Next";
10. "Position 0.5l container under spouts. Press OK to fill fil-
ter": place an empty container with a minimum capacity
of 0.5 litres under the hot water/steam spout (F) (fig. 8)
and press "OK".
11. "Rinsing underway. "Hot water from spouts": delivery be-
gins and stops automatically;
12. "Water filter installed": press "OK". The filter is now active
and you can use the coffee machine.
20.2 Replacing the filter
Replace the filter (C6) when "REPLACE WATER SOFTENER FILTER,
PRESS OK TO START" appears on the display (B1). To replace the
filter immediately, press "OK" and follow the instructions from
point 6. To replace the filter later, press "Cancel". The symbol
(B9) appears on the display to remind you that the filter needs
replacing.
To replace, proceed as follows:
1. Remove the new filter from the packaging;
2. Press the settings menu (B6);
3. Select "Replace water filter";
4. "Press OK to replace water filter": press "OK" to enter the
guided procedure;
5. "Remove current filter before installing a new one": press
the (A15) button, open the front door (A16) (fig. 3) and
extract the water tank (A25) and exhausted filter. Press
"Next" to continue ("Back" to go back to the previous
screen; "Cancel" to cancel the operation);
6. Follow the operations described in the previous section
from point (4).
22. DISPLAYED MESSAGES
DISPLAYED MESSAGE
FILL TANK WITH FRESH
WATER. USE REFILL FUNNEL
OR REMOVE WATER TANK
POSSIBLE CAUSE
Insufficient water in the tank (A25).
Please note!
After two months (see date indicator) or when the appliance has
not been used for 3 weeks, you should replace the filter even if
the message has not yet been displayed.
20.3 Removing the filter
If you want to use the appliance without the filter (C6), you
must remove it and notify the appliance of its removal. Proceed
as follows:
1. Press the button (A15), open the front door (A16) (fig. 3)
and extract the water tank (A25) and exhausted filter;
2. Press the settings menu (B6);
3. Select "Remove water filter";
4. "Press OK to confirm filter removal": press OK to confirm;
5. "Filter removed": the change has been saved. Press "OK" to
go back to the homepage (B).
Please note!
After two months (see date indicator) or when the appliance has
not been used for 3 weeks, you should replace the filter even if
the message has not yet been displayed.
21. TECHNICAL DATA
Voltage:
Power:
Pressure:
Water tank capacity:
Size LxDxH:
Cord length:
Weight:
Beans container capacity:
Frequency:
Maximum transmission power
REMEDY
Press the button (A15), open the door (A16)
(fig. 3), extract the tank and fill with fresh
water, then put back in the appliance and close
the door.
Alternatively, you can top up the tank by pour-
ing the water through the refill door (A23) and
checking the level through the transparent
window in the side of the tank. Important:
never pour water through the refill door
when the tank has been extracted
25
220-240 V~ 50-60 Hz max. 10 A
1550 W
1.9 MPa (19 bars)
290x468x405mm
1750 mm
16.8 kg
290g (x2)
2400/2483.5 MHz
10 mW
2.1 l
Advertisement
Table of Contents
Troubleshooting
