Table of Contents
Advertisement
2. After setting the parameters, press
cup, or (if possible for the selected beverage)
make 2 cups. The appliance starts making the coffee and
the image of the selected beverage appears on the display,
together with a progress bar which gradually fills as the
operation proceeds and a description of each individual
phase (grinding, brewing coffee);
3. At the end of delivery, the message: "Your beverage is
ready! Save new settings?" is displayed;
4. Press "Save" to save the settings, or "Cancel" to retain the
previous parameters.
Please note!
If you save the new settings, they are memorised ONLY in the
selected profile.
5. "New settings saved on current profile": press "OK" to go
back to the homepage (main screen).
The appliance is ready to be used again.
7.4 Making coffee using pre-ground coffee
Important!
•
Never add pre-ground coffee when the machine is off or it
could spread through the inside of the machine and dirty
it. This could damage the machine.
•
Never use more than 1 level measure (C2) as it could soil
the inside of the coffee machine or block the funnel (A3).
•
When using pre-ground coffee, only one cup can be made
at a time.
•
Making LONG coffee: halfway through preparation, the
message "ADD PRE-GROUND COFFEE, MAXIMUM ONE
MEASURE" is displayed. Add one level measure of pre-
ground coffee and press "OK".
You cannot make a DOPPIO+ coffee using pre-ground
•
coffee.
1. Lift the pre-ground coffee funnel lid (A1)(fig. 16);
2. PRE-GROUND LID OPEN. DO YOU WANT TO USE PRE-
GROUND COFFEE?": Press "Next" to proceed (or "Cancel" to
stop and go back to the homepage);
3. "ADD PRE-GROUND COFFEE , MAXIMUM ONE MEASURE":
make sure the funnel (A3) is not blocked, then add one
level measure of pre-ground coffee (fig. 13).
• Press "OK" to proceed with preparation;
4. "PRE-GROUND MODE" is displayed on the homepage: pro-
ceed as described in section "7.2 Your coffee at a touch" or
"7.3 Customising the beverages" above.
Please note!
To exit pre-ground mode, after point 4, open the pre-ground lid
and press "Cancel".
2X
1X
to make 1
2X
to
1X
7.5 General indications for making coffee-based
beverages
•
While the machine is making coffee, delivery can be inter-
rupted at any moment by pressing "Stop" or "Cancel".
•
Various alarm messages could be displayed while using
the appliance ("FILL TANK WITH FRESH WATER", "EMPTY
GROUNDS CONTAINER", "EMPTY DRIP TRAY" ETC.). Their
meaning is explained in section "22. Displayed messages".
•
If the coffee is delivered a drop at a time, too weak and not
creamy enough or too cold, read the tips in sections "6.4
Adjust mill" and "23. Troubleshooting".
•
If "Energy Saving" mode is active, you may have to wait a
few seconds before the first coffee is delivered
7.6 Tips for a hotter coffee
For hotter coffee, proceed as follows:
•
perform a rinse cycle by selecting "Rinsing" in the settings
menu (B6) (section "6.1 Rinsing");
•
warm the cups with hot water using the hot water function
(see section "13. Delivering hot water");
•
increase the coffee temperature (section "7.3 Customising
the beverages").
8. CARAFE OF COFFEE
To make the beverage, press the image on the homepage corre-
sponding to the carafe of coffee and proceed as follows:
1. "BEVERAGE SETTINGS": The parameters that can be cus-
tomised according to your tastes appear on the display:
Cups
"Aroma"
Coffee type
"Temperature"
2. Position a carafe under the coffee spouts (A11). When
choosing the carafe to use, bear in mind the quantity to
be delivered, namely:
Selected quantity
3. Press "Next" to move on to the next step;
4. If you select 4 or 6 cups, "The machine will brew 2 (or 3)
times" appears on the display. "Fill water tank and beans
containers if needed": make sure there is sufficient water
and coffee, then press OK;
12
Quantity (ml)
250
500
750
Advertisement
Table of Contents
Troubleshooting
