Water Softener Filter; Installing The Filter; Replacing The Filter - DeLonghi Dinamica Plus Instructions For Use Manual

Indicator paper
5. Press to go back to the homepage.
The machine is now reprogrammed with the new water hard-
ness setting.

15. WATER SOFTENER FILTER

Certain models come equipped with a water softener filter (D4):
if this is not the case with your model, we would advise pur-
chasing one from a De'Longhi approved service centre. To use
the filter correctly, follow the instructions below.

15.1 Installing the filter

1. Access the menu as described in section "6.1 Access the
menu";
2. Press "WATER FILTER";
3. "TURN DATE INDICATOR TO NEXT 2 MONTHS" (fig. 37): re-
move the new filter (D4) from the pack and turn the date
indicator disk so that it shows the next 2 months of use.
Press ;
37
Please note
IThe filter lasts about two months assuming normal use of the
machine; if on the other hand the machine remains idle with the
filter installed, it will not last more than three weeks, at most.
4. "RUN WATER INTO FILTER HOLE" "UNTIL IT COMES OUT" (fig.
38): To activate the filter, run tap water through the central
hole of the filter as shown in the figure until water comes
out of the openings at the side for more than one minute.
Press ;
5. Extract the tank (A17) from the appliance and fill with
water.
6. "IMMERSE FILTER TO RELEASE AIR BUBBLES" (fig. 39): In-
sert the filter in the water tank and immerse it completely
Water hardness
Level 4 - very hard water
38
for about ten seconds, tilting it and applying light pressure
so that the air bubbles can escape.
Press
7. "INSERT FILTER" "IN HOUSING": Insert the filter (D4) in
the filter housing (fig. 36) and press fully home. Press
;
8. "INSERT WATER TANK": Close the tank with the lid (A16),
then reposition the tank in the machine (fig. 4);
9. "POSITION 0.5L CONTAINER, OK TO ENABLE FILTER" (fig.
6): Place the container under the hot water spout (D6) and
press
starts and stops automatically.
The filter is now activated and the machine can be used.

15.2 Replacing the filter

Replace the filter (D4) when "REPLACE WATER FILTER" "PRESS
OK TO START" appears on the display: to replace immediately,
press and follow the instructions from point 5 of
the preceding section.
To delay replacement of the filter until later, press
The symbol (B8) appears on the display as a reminder that
the filter needs replacing. To replace, proceed as follows:
1. Access the menu as described in section "6.1 Access the
menu";
2. Press "WATER FILTER";
3. Press "REPLACE FILTER"
4. First remove the tank (A17) and the spent filter, then fol-
low the operations described in the previous section from
point 3 onwards.
Please note!
After two months (see date indicator), or after 3 weeks if the
appliance has not been used, the filter should be replaced even
if the warning message has not yet been displayed.
19
;
39
: "HOT WATER PLEASE WAIT" delivery
.