Cleaning The Coffee Spouts; Cleaning The Pre-Ground Coffee Funnel; Cleaning The Infuser - DeLonghi Maestosa EPAM96X.75 Instructions For Use Manual

2. Extract the water tank (fig. 4), remove the water softener filter
(if present) and rinse it with running water;
3. Empty the water tank and clean with a damp cloth and a little
washing up liquid. Rinse thoroughly with water;
4. Put the filter back in the appliance (fig. 63), fill the tank with
fresh water up to the MAX level (marked inside) (fig. 5), put the
tank back (fig. 6) and close the door;
5. (models with a water softener filter only) Deliver 100ml of hot
water.

17.7 Cleaning the coffee spouts

48A
48B
funnel
5. Close the lid.

17.9 Cleaning the infuser

The infuser (A27) must be cleaned at least once a month.
Important!
The infuser cannot be extracted when the machine is on.
1. Clean the coffee spouts
(A17) regularly with a
sponge or the cloth (C9)
provided (fig. 48A);
2. Check that the holes in
the coffee spout are not
blocked. If necessary, re-
move coffee deposits with
a toothpick (fig. 48B).
17.8 Cleaning the
pre-ground coffee
Clean the pre-ground coffee
funnel (A3) regularly (about
once a month) with a damp
cloth. Proceed as follows:
1. Open the lid (A1) (fig. 16);
2. Extract the funnel (fig. 49)
and clean with the brush
provided (C5);
3. If necessary, clean the
funnel with hot water and
washing up liquid or in a
dishwasher;
49
4. Put the funnel back in
the appliance;
1. Make sure the machine is correctly turned off (see "5. Turn-
ing the appliance off");
2. Press the button (A15), open the door (A16) and extract
the water tank (A25) (fig. 4);
3. Open the infuser door (A26) (fig. 50) on the right side of
the appliance;
4. Press the two coloured release buttons inwards and at the
same time pull the infuser outwards (fig. 51);
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap;
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID - NO DISHWASHER
6. Clean the infuser without using washing up liquid as it
could be damaged.
7. Use the brush (C5) to remove any coffee residues left in the
infuser housing, visible through the infuser door;
8. After cleaning, put the infuser back in the appliance, in-
serting it in the support (fig. 52);
9. Once inserted, make sure the two coloured buttons have
snapped out (fig. 53);
10. Close the infuser door;
11. Put the water tank back and close the front door.
21
50
52
51
53