Installing The Filter; Replacing The Filter - DeLonghi ECAM35075 Manual

16.1 Installing the filter

1. Remove the filter (C4) from the packaging. The date indica-
tor disk varies according to the filter provided.
2. Turn the date indicator disk (fig. 35) until the next 2
months of use are displayed.
35
Please note
The filter lasts about two months if the appliance is used nor-
mally. If the coffee machine is left unused with the filter in-
stalled, it will last no longer than 3 weeks.
3. To activate the filter, run tap water through the hole in the
filter as shown in figure 36 until water comes out of the
openings at the side for more than a minute;
4. Extract the tank (A17) from the appliance and fill with
water;
5. Insert the filter in the water tank and immerse it complete-
ly for about ten seconds, sloping it and pressing it lightly to
enable the air bubbles to escape (fig. 37).
37
6. Insert the filter in the filter housing (A18) and press fully
home (fig. 38);
7. Close the tank with the lid (A16) (fig. 39), then replace the
tank in the machine;
0,5 L
36
38
When you install the filter you must notify the appliance of its
presence.
8. Press (B6) to enter the "Settings" menu;
9. Press the selection arrows (B2) and (B4) until "Mainte-
nance" is displayed between the two lines. Press
10. Press the selection arrows until "Install filter" is displayed,
then press ;
11. Press again;
12. Position a container under the hot water spout (C6) (min.
capacity: 500 ml), then press
13. The appliance starts delivering water;
14. After the flow of hot water stops, the machine automati-
cally reverts to "Ready for coffee" status.
The filter is now active and you can use the coffee machine.

16.2 Replacing the filter

Replace the filter (C4) when "Replace filter, ESC to cancel, OK
to replace" appears on the display (B1). To replace immediate-
ly, press (B3) and follow the instructions from point 8. To
replace the filter later, press
on the display to remind you that the filter needs replacing.
To replace, proceed as follows:
1. Extract the tank (A17) and exhausted filter;
2. Take the new filter out of its packet and proceed as illus-
trated in points 2, 3, 4, 5, 6 and 7 in the previous section;
3. Press (B6) to enter the "Settings" menu;
4. Press the selection arrows (B2) and (B4) until "Mainte-
nance" is displayed between the two lines. Press
5. Press the selection arrows until "Replace filter" is displayed,
then press ;
6. Press to confirm;
7. Position a container under the hot water spout (C6) (min.
capacity: 500 ml), then press
8. The appliance starts delivering water;
9. After the flow of hot water stops, the machine automati-
cally reverts to "Ready for coffee" status.
The new filter is now active and the coffee machine can be used.
20
39
;
;
(B5). The symbol appears
;
;