Description Of The Milk Container; Description Of "Mix Carafe; Description Of Hot Water/Steam Spout; Setting Up The Appliance - DeLonghi Maestosa EPAM96X.75 Instructions For Use Manual

2.4 Description of the milk container

(page 2 - D )
D1. Milk container lid
D2. Milk container connector (removable for cleaning)
D3. Milk refill lid
D4. Milk container lid release button
D5. Milk intake tube
D6. Milk spout (adjustable height)
D7. Milk container
D8. Thermal casing

2.5 Description of "Mix carafe"

(page 2 - E )
E1. "Mix carafe" lid
E2. Mix carafe connector (removable for cleaning)
E3. Funnel
E4. Steam spout ("choco" accessory)
E5. Choco stirrer ("choco" accessory)
E6. Aero stirrer ("aero" accessory)
E7. "Mix carafe"
E8. Funnel release slide

2.6 Description of hot water/steam spout

(page 2 - F )
F1. Spout body
F2. Spout connector (removable for cleaning)
F3. Spout release button
F4. Hot water/steam connection nozzle
F5. Cappuccino maker

3. SETTING UP THE APPLIANCE

Please note!
• Coffee has been used to factory test the appliance and it
is therefore completely normal for there to be traces of
coffee in the mill. The machine is, however, guaranteed to
be new.
• You should customise water hardness as soon as possible
following the instructions in section "19. Setting water
hardness".
• The control panel (B) can be swivelled to make sure the
homepage is always visible.
1. Plug the power cord connector (C6) into the socket (A13) at
the back of the appliance and connect the appliance to the
mains electricity supply (fig. 1). Make sure the main switch
(A12) at the back of the appliance is pressed (fig. 2);
2. "SELECT LANGUAGE": Press the flag corresponding to the
desired language.
Then follow the instructions which appear on the appliance
display (B1):
3. "FILL TANK WITH FRESH WATER. USE BUTTON ON THE RIGHT
TO OPEN THE FRONT DOOR":
• Press the button (A15) and open the door (A16) (fig. 3);
• Remove the water tank (A25) (fig. 4) and fill to the MAX
line (marked on the inside of the tank) with fresh water
(fig. 5);
• Then put the tank back (fig. 6) and close the door;
• Check that the hot water/steam spout (F) is inserted on
the connection nozzles(A11) (fig. 7) and place a con-
tainer holding a minimum of 100 ml underneath (fig.
8);
• Press "Next".
4. "FILL BEANS CONTAINERS AND PRESS Next": fill beans con-
tainer (I) (A4) and, if you want to also use another quality
of coffee, beans container (II) (A6) (fig. 12), then confirm
by pressing "Next".
5. "WATER CIRCUIT EMPTY. PRESS OK TO START FILLING": con-
firm by pressing "OK";
6. "MACHINE SETUP UNDERWAY. AFTER IT GOES OFF TURN ON
AGAIN": the appliance delivers water from the spout (fig.
9);
7. The appliance goes off.
The coffee machine is now ready for normal use. Turn on follow-
ing the instructions in section "4. Turning the machine on".
Please note!
• The first time you use the appliance, you need to make
4-5 cappuccinos before the results in the cup will be
satisfactory.
• The first time you use the machine, the water circuit is
empty and the appliance could be very noisy. The noise
becomes less as the circuit fills.
• When making the first 5-6 cappuccinos, it is normal to hear
the noise of boiling water. After this, the noise becomes
less.

4. TURNING THE MACHINE ON

Please note!
• Before turning the appliance on, make sure the main
switch (A12) is pressed (fig. 2).
• Each time the appliance is turned on, it performs an auto-
matic preheat and rinse cycle which cannot be interrupted.
The appliance is ready for use only after completion of this
cycle.
1. To turn the appliance on, press the
10). The message "HEATING UP UNDERWAY" appears on
the display (B1);
2. When at temperature, the appliance performs a rinse cycle
delivering hot water from the coffee spouts (A17) and
the message "RINSING UNDERWAY, HOT WATER FROM
8
button (A8) (fig.