Table of Contents
Advertisement
Please note!
•
If "Energy Saving" mode is active, you may have to wait a few
seconds before the hot water is delivered.
•
To interrupt delivery of hot water manually, press "Stop"
and "Cancel".
14. STEAM DELIVERY
41
3. Press the image on the homepage corresponding to steam.
The appliance proceeds with preparation and the image of
the beverage appears on the display together with a pro-
gress bar which gradually fills as the operation proceeds
and a description of the phase (steam delivery);
4. At the end of preparation, the message "Your beverage is
ready!" appears on the display. The appliance is now ready
to be used again.
Important!
Always shut off the steam before the container with the heated
liquid is drawn clear of the spout, as splashes can cause scalding.
The message "Your beverage is ready!" appears on the display.
The appliance is now ready to be used again.
Please note!
•
If "Energy saving" is active, you may have to wait a few
seconds before steam is delivered.
•
To stop delivery manually, press "Stop" or "Cancel"
14.1 Tips for using steam to froth milk
•
When choosing the appropriate size of container, remem-
ber that the liquid will double or triple in volume.
•
For a richer and denser froth, use skimmed or partially
skimmed milk from the refrigerator (about 5°C).
•
For a creamier froth, swirl the container slowly, moving it
from the bottom upwards.
•
To avoid milk with poor froth or large bubbles, always clean
the spout (F) as described in the following section.
To deliver steam, proceed as
follows:
1. Attach the hot water/
steam spout (F) to the con-
nection nozzles (A11) (fig.
7): the appliance beeps
(if the beep function is
enabled);
2. Fill a container with the
liquid to be heated or
frothed and immerse the
hot water/steam spout in
the liquid (fig. 41);
14.2 Cleaning the hot water/steam spout after
use
Always clean the hot water/steam spout (F) after use to avoid the
build-up of milk residues and prevent it from clogging.
1. Place a container under the hot water/steam spout and de-
liver a little water (see section "13. Delivering hot water").
Stop delivery of hot water by pressing "Stop";
2. Wait a few minutes for the hot water/steam spout to cool
down, then extract (fig. 21) by pressing the release button
(F3);
3. Turn the connector (F2) anticlockwise and extract (fig. 42);
4. Hold the spout (F1) with one hand and with the other, turn
the cappuccino maker (F5) and pull it downwards (fig. 43).
Also remove the steam connection nozzle (F4) by pulling
it downwards;
5. Check the hole in the connection nozzle is not blocked. If
necessary, clean using a toothpick.
6. Wash all components of the spout thoroughly with a
sponge and warm water. Use the tube brush (C8) to scrape
off any milk residues.
7. Replace all the spout components correctly.
15. GUIDED BEVERAGE CUSTOMISATION (MY)
You can use this function to customise all beverages with the MY
symbol at the bottom of the image in beverage settings (on the
homepage, press
at the bottom of the image correspond-
ing to the required beverage). To customise, proceed as follows:
1. Make sure the profile (B2) for which you want to customise
the beverage is active;
2. Press
(B4) at the bottom of the image corresponding
to the desired beverage;
3. Press
at the bottom of the image corresponding to the
beverage;
4. "Press OK to enter a guided process to customise your
beverage": press "OK" and follow the instructions on the
display.
18
42
43
Advertisement
Table of Contents
Troubleshooting
