Table of Contents
Advertisement
DISPLAYED MESSAGE
PRE-GROUND MODE IS
NOT ALLOWED WITH THIS
BEVERAGE
FILL BEANS CONTAINERS
NOT ENOUGH COFFEE.
CONSULT MANUAL OR
CUSTOMER SERVICES
NEW SETTINGS NOT SAVED
POSSIBLE CAUSE
The pre-ground coffee function has been se-
lected for a beverage where use of pre-ground
coffee is not possible/envisaged.
The beans present sensor is dirty and not work-
ing correctly
The machine must be descaled
and/or the filter must be replaced (C6)
Energy saving is enabled.
The machine must be descaled.
The filter must be replaced (C6)
This indicates that one or both the beans con-
tainers ((A4) and (A6)) are empty
Indicates that the appliance is connected to a
device via bluetooth."
While customising the beverages (see section "15.
Guided beverage customisation (My)"), preparation
has been deliberately interrupted by pressing "Can-
cel" or an alarm has been triggered.
REMEDY
Press "OK" to go back to the previous screen.
Remove the dust from the sensors using a cot-
ton bud.
The descaling procedure described in section
"18. Descaling" needs to be performed and/
or the filter needs replacing or removing as de-
scribed in section "20. Water softener filter".
To disable energy saving, proceed as described
in section "6.7 General".
The descaling procedure described in section
"18. Descaling" needs to be performed.
Replace the filter or remove it as described in
section "20. Water softener filter".
Fill the beans container(s)
Press "OK" to go back to the homepage to view the
alarm causing the interruption. Follow the instruc-
tions corresponding to the alarm displayed (see sec-
tion "22. Displayed messages")
30
Advertisement
Table of Contents
Troubleshooting
