Page 3
page 4 Decalci cante per macchine da ca è Descaler for co ee machines Détartrant pour machines à café Entkalker für Ka eemaschinen De’Longhi Appliances s.r.l. Via L. Seitz, 47 31100 Treviso - ITALY Tel. +39 0422 4131 5413218631/04.15 ✕ ✕...
CONTENTS 16. DESCALING ...........19 1. INTRODUCTION ........5 17. EXPLANATION OF LIGHTS ......21 1.1 Letters in brackets ........5 18. TROUBLESHOOTING ......23 1.2 Troubleshooting and repairs ....5 19. TECHNICAL DATA ........24 2. DESCRIPTION ......... 5 2.1 Description of the appliance - A ....5 2.2 Description of control panel - B ....5 2.3 Description of indicator lights - C ....5 2.4 Description of accessories - D* ....5...
2.5 Description of milk carafe - E If repairs are required, contact De’Longhi customer services only. Addresses can be found on the website www.delonghi. E1. Lid with milk frother com. E2. Milk spout connector (non removable) E3.
• Possible traces of coffee in the grinder are the result of operating tests performed on the appliance before sale, proof of the meticulous care and attention we invest in our products. • The first time the machine is used, the water circuit will be empty and the appliance could be very noisy.The noise becomes less as the circuit fills.
9. On the control panel, the filter indicator light (C1) blinks filter. steadily and the Led of the clean carafe/manual rinse but- For more information, visit the www.delonghi.com website. ton (B6) blinks rapidly; 10. Press the clean carafe/manual rinse button (B6) (fig. 17);...
that the descale indicator (C5) will light up as necessary according to the actual hardness of the local water supply. Proceed as follows: 11. The appliance delivers hot water, then stops automatically; 12. When the flow stops, the filter indicator light extinguish- es: the filter is now active and the machine can be used.
The appliance is ready for use when the drinks and intensity Drink D e f a u l t Programmable quantity Leds remain permanently alight. q u a n t i t y (ml) (ml) 7. TURNING THE APPLIANCE OFF ≃...
8.7 Tips for a hotter coffee 4. Select the required drink (B7); To make a hotter coffee, proceed as follows: 5. Preparation begins and the Led corresponding to the se- “ • run a rinse cycle (see section “8.6 Rinsing ”...
the connector (E6) (located internally of the milk contain- er) is inserted correctly in its socket (fig. 11-12). • To ensure that milk is not under-frothed or topped with large bubbles, always clean the milk carafe lid (E1) and the carafe connector (E6) as described in sections “9.6 Cleaning the milk carafe after each use”, and “14.
9.6 Cleaning the milk carafe after each use 5. Close the carafe: refit the lid (the reference mark on the lid Following each delivery of a milk-based drink, the Led associ- must be aligned with the symbol) then turn toward ated with the clean carafe button (B6)will blink on the control symbol until locked in position (fig.
10.1 Customising the quantity of hot water Following preparation of milk-based drinks — general notes: 1. Press the Hot water button and hold for a few sec- • In certain cases, the machine will need to heat up before onds: the light blinks rapidly to indicate that the program- cleaning can take place.
12. SETTINGS MENU Having accessed the menu, the buttons that remain active can be used to select the corresponding functions: Selection of Access to Beep settings settings menu Water softener filter Auto-off Coffee temperature Energy saving Water hardness Drinks differing according to model 1.
Page 15
Coffee temperature Confirm selection Press the bean symbol MEDIUM corresponding to the required temperature HIGH Energy saving Confirm selection Press one of the bean symbols to enable energy saving Press the pre-ground symbol to disable energy saving LEVEL 1 Water hardness Confirm selection LEVEL 2 Press the symbol...
12.1 Restore factory settings Make sure the machine is in stand-by (off, but connected to the mains power supply). Press the buttons corresponding to drinks 1, 2 and hold for 5 seconds: all machine settings and drink quantities will be reset to the default factory values. The machine emits a long beep and all indicator lights blink to confirm the reset 13.
Page 17
Component Frequency Procedure Grounds container • Remove the drip tray, empty and clean. indicator lights up, the When the • Empty the grounds container and clean thoroughly grounds container must be emptied: the to remove all residues that may have collected on machine cannot now make coffee.
14. THOROUGH CLEANING OF MILK CARAFE Clean the milk carafe as described below: 1. Release the lid (E1)by turning clockwise: the reference mark on the lid must be aligned with the symbol (fig. 24); 2. Now lift the lid (fig. 25). 3.
• Descaler can cause damage to delicate surfaces. If the product is accidentally spilt, dry immediately. To descale Descaler De’Longhi descaler Container Recommended capacity: 2l Time ~30min Accessory Hot water spout (D5) Important: 5. Immerse the infuser in water for about 5 minutes, then If the water softener filter is installed, it must be re- rinse under the tap;...
Page 20
9. Press the button (which blinks rapidly) to start the 5. Place an empty container of at least 2 litres capacity under rinse: the medium intensity Led blinks to indicate that the coffee spouts (A16) and the water spout (D5) (fig. 47). step 2 of the descale cycle is in progress;...
17. EXPLANATION OF LIGHTS Indicator/Led Meaning Indicator/Led Meaning No coffee beans: fill the beans container, then press Drink indicators blinking The machine is warming up: any button to exit the alarm wait condition. Drink and settings indicators The machine is ready for permanently alight use: select the desired drink and relative options...
Page 22
Indicator/Led Meaning Indicator/Led Meaning • A milk drink has been The grounds container (A10) is missing, or not inserted selected, but the milk correctly: insert the drip tray container is not fully complete with the grounds assembled or not cor- container and press fully rectly in place: check home...
18. TROUBLESHOOTING Possible malfunctions of the machine are listed below. If the problem cannot be resolved as described, contact customer services. Problem Cause Solution The appliance does not switch on. The cord is not plugged into the mains Plug into the mains socket. socket.
Problem Cause Solution With the descaling procedure completed, During the two rinse cycles, the water Restart the descaling procedure from “Step the appliance prompts for a third rinse tank was not filled to the MAX level Second rinse”. The milk presents large bubbles or Milk is not cold enough, or is not semi- Use skimmed or semi-skimmed milk skimmed or skimmed.
Need help?
Do you have a question about the Magnifica Evo and is the answer not in the manual?
Questions and answers