Table of Contents
Advertisement
DISPLAYED MESSAGE
INSERT WATER TANK
CLOSE FRONT DOOR
STOP FILLING, WATER TANK
FULL
WATER CIRCUIT EMPTY. PRESS
OK TO START FILLING
INSERT INFUSER ASSEMBLY
POSSIBLE CAUSE
The tank (A25) is not correctly in place.
The front door (A16) is open or not closed
correctly.
The water tank (A25) is full.
The water circuit is empty
A new water softener filter has been inserted
(C6)
The infuser (A27) has not been replaced after
cleaning.
REMEDY
Insert the tank correctly and press as far as it
will go.
Close the front door and press until it clicks into
place, the machine emits a beep (if the beep
function is enabled).
Stop filling immediately to avoid water over-
flowing from the water tank. Press " OK" to
confirm and go back to the homepage (B).
Place a container with a minimum capacity of
100 ml under the hot water/steam spout (F)
and press "OK" to deliver water. Delivery stops
automatically.
If the problem persists, make sure the water
tank (A25) is fully inserted.
Make sure you have followed the instructions
for inserting the new filter (section "20.1 In-
stalling the filter" and "20.2 Replacing the
filter"). If the problem continues, remove the
filter (section "20.3 Removing the filter").
Insert the infuser as described in section "17.9
Cleaning the infuser"
26
Advertisement
Table of Contents
Troubleshooting
