How To Install A Power Supply; Before You Begin; What To Do - Sun Microsystems Enterprise 220R Service Manual

6.2

How to Install a Power Supply

6.2.1

Before You Begin

If you are installing a redundant power supply, it is not necessary to power off the
system. For more information, see "About Power Supplies" in your Sun Enterprise
220R Server Owner's Guide.
6.2.2

What to Do

1. Unlock the system doors and swing them open.
Turn the keyswitch to the Power-On/Off position. This unlocks the system front
access doors.
2. Loosen the Phillips screw that secures the power supply retaining clip until
you can push the clip upward.
3. If you are upgrading your system with an additional power supply, remove the
filler panel covering the power supply bay.
a. With one hand, push up the retaining clip until it clears the filler panel.
b. Partially pry the top of the filler panel out of the bay, using a flat-blade
c. Lift the filler panel out and away from the bay, and set it aside.
d. Keep the filler panel in case you need to remove the power supply later.
4. Using your thumb, push up the retaining clip until there is enough clearance to
slide the power supply into its bay.
162
Sun Enterprise 220R Server Service Manual
screwdriver.
The filler panel maintains proper system cooling and prevents electromagnetic
interference in the absence of a second power supply.
January 2000, Revision A