Requirements For Installation; Required Information; Required Equipment - Intuicom RTK Bridge-X Installation Manual

Overview
®
The Trimble XCN-2050™ receiver is typically configured to accept CMR format RTK
corrections from an Intuicom RTK Bridge
GPS/GNSS reference network. The intended audience for this document are dealers or
integrators familiar with the XCN-2050 and access to its set-up menus, as well as general
familiarity with the Intuicom RTK Bridge
covers the steps necessary for its configuration.

1 Requirements for Installation

1.1

Required Information

In order to operate an Intuicom RTK Bridge
information to access and log in to the Real-Time Network. This information is entered
into the RTK Bridge
–X is available in the RTK Bridge
®
Bridge
Profile configuration include:

IP Address

TCP Port

NTRIP Mountpoint Name

Username and Password for access to the real-time GPS/GNSS Network
1.2

Required Equipment

1.2.1 Intuicom Equipment and Accessories
1. Intuicom RTK Bridge
etc.)
2. Intuicom RTK Bridge
DD6]
3. Intuicom RTK Bridge
4. Intuicom RTK Bridge
[P/N: FIP4-MMDM-MM (magnetic mount)]
1.2.2 Other Equipment and Accessories
5. Trimble XCN-2050 Receiver with RTK (CMR) option enabled and Port D available
6. Trimble XCN-2050 Data Cable and source of power for Trimble XCN-2050 (or any
cabling system typically used to run the Trimble XCN-2050 for configuration)
7. Trimble EXP-100 Port Expander
Version 1.0
®
-X, which in turn has been configured to connect to a
–X. The Intuicom RTK Bridge
®
–X and stored in a profile. More details on setting up an RTK
®
®
–X with activated data provider account (Verizon, AT&T,
®
–X to XCN-2050 data/power cable: [P/N: XRTKCAB-
®
–X Bluetooth Receiver: [P/N: XRTK-BT-T]
®
–X Cellular/GPS antenna/cable:
®
2
Section 1: Installation Requirements
–X, you are required to have the necessary
®
-X User Guide. Required information for the
–X User Guide
®
Intuicom, Inc.