Requirements For Installation; Required Information; Required Equipment - Intuicom RTK Bridge-X Installation Manual

Overview
The Trimble® FMX/Case IH FM-1000 receiver is typically configured to accept CMR format
RTK corrections from an Intuicom RTK Bridge®-X which in turn has been configured to
connect to a GPS/GNSS reference network. The intended audience for this document is a dealer
or integrator familiar with the FMX and access to the Set-up menus as well as general familiarity
with the Intuicom RTK Bridge–X. The Intuicom RTK Bridge–X User Guide covers the steps
necessary for its configuration.

1 Requirements for Installation

1.1

Required Information

In order to operate an Intuicom RTK Bridge–X, you are required to have the necessary
information to access and log in to the Real-Time Network. This information is entered
into the RTK Bridge–X and stored in a profile. More details on setting up an RTK
Bridge–X is available in the RTK Bridge-X manual.
IP address,
•
TCP port,
•
NTRIP mountpoint name,
•
username and password for access to the real-time GPS/GNSS network
•
1.2

Required Equipment

1.2.1 Intuicom Equipment and Accessories
1. Intuicom RTK Bridge–X with activated data provider account (Verizon, AT&T, etc...)
2. Intuicom RTK Bridge–X to FMX data/power cable:
[P/N: XRTKCAB-DD6]
3. Intuicom RTK Bridge–X Cellular/GPS antenna/cable:
[P/N: FIP4-MMDM-MM (magnetic mount)]
1.2.2 Other Equipment and Accessories
4. Trimble FMX receiver with RTK (CMR) option enabled and Port D available
5. Trimble FMX Data Cable and source of power for Trimble® FMX/Case IH FM-1000 (or
any cabling system typically used to run the Trimble® FMX/Case IH FM-1000 for
configuration)
Version 1.0
Section 1: Installation Requirements
2 Intuicom, Inc.