Installation Requirements; Required Information; Required Equipment; Intuicom Equipment And Accessories - Intuicom RTK Bridge-X Installation Manual

Overview
The AGI-3 and/or AGI-4 receiver(s) are typically configured to accept RTCM format RTK
corrections from an Intuicom RTK Bridge®-X which in turn has been configured to connect to a
GPS/GNSS reference network. The intended audience for this document is a dealer or
integrator familiar with the Topcon receivers and access to the Set-up menus as well as general
familiarity with the Intuicom RTK Bridge–X. The Intuicom RTK Bridge–X User Guide covers
the steps necessary for its configuration.
1 Requirements for Installation
1.1

Required Information

In order to operate an Intuicom RTK Bridge–X, you are required to have the necessary
information to access and log in to the Real-Time Network. This information is entered
into the RTK Bridge–X and stored in a profile. More details on setting up an RTK
Bridge–X is available in the RTK Bridge-X manual.
IP address,
•
TCP port,
•
NTRIP mountpoint name,
•
username and password for access to the real-time GPS/GNSS network
•
1.2

Required Equipment

1.2.1 Intuicom Equipment and Accessories

1. Intuicom RTK Bridge–X with activated data provider account (Verizon, AT&T,
etc...)
2. Intuicom RTK Bridge–X to Topcon data/power cable:
o AGI-3 – [P/N: XRTKCAB-AGI3] (Deutsch to crimped leads and SAE)
o AGI-4 – [P/N: XRTKCAB-AGI4] (Deutsch to Deutsch)
3. Intuicom RTK Bridge–X Cellular/GPS antenna/cable:
[P/N: FIP4-MMDM-MM (magnetic mount)]

1.2.2 Other Equipment and Accessories

Topcon receiver (AGI-3 or AGI-4) with RTK unlocked
5.
Topcon monitor (Example given is for the X30, but any monitor could be used)
6.
Version 1.0
Section 1: Installation Requirements
2 Intuicom, Inc.