Table of Contents
Advertisement
If the pole is installed on a slope, install the sensor higher or lower in order to adjust
NOTE
●
the height of the set detection range to 500mm(19.69in.) from the ground. It may
reduce the detection capability compared to the normal installation.
Do not install any moving object such as flags or banners in the sensor's detection
●
area. Remove any vegetation from the detection area, or reconfigure the detection
area to be smaller. Not following these steps may stop the sensor reverting back to
non-detection status or delay the change of status.
Do not use a fluorescent lamp around the detection area. It may prevent proper
●
operation of the sensor.
500mm(19.69in.)
Height of the set detection range
Ground
-6-
Advertisement
Table of Contents
