Table of Contents
Advertisement
4
Installation Steps (Basic)
4-1
Installation of the Unit
■Required Tools■
●Precision screwdriver, Phillips #1 ●Screwdriver, Phillips #2
[1] Drill pilot holes into the poles and attach the sensor.
[2] Run the wire through the poles.
[3] Fix the poles so that the sensor faces the angle shown below.
90°
For fine angle adjustment after fixing to the poles, rotate the sensor unit to the correct angle.
The sensor angle is adjustable up to 30 degrees to the left and right by 5 degree increments.
-10-
Mounting
Pitch 32±1
(1.26±0.04)
[Unit : mm(inch)]
Advertisement
Table of Contents
