Response Time - Optex TS-1000-D Instruction Manual

Measurement item
Main Suspended solids
display
Transparency
2nd -
display
Suspended solids
Transparency
The following display resolutions are available.
SS
・ 0.0 - 49.9: 0.1
・ 50 - 1000: 1
Transparency
・ 0 - 100: 1

Response time

Set a signal output response time.
A measurement value is calculated using moving average of the time period
set by the signal output response time.
For example, if the sensor measures values every 5 seconds and the signal
output response time is set to 50 seconds, which is 5 seconds × 10 times,
the moving average of 10 times measurement is calculated and used as the
measurement value.
For operation, refer to the "Universal Transmitter SC-U1 Operation
Manual", "5.1 Sensor Setting" and " ◆ Response Time".
Response 5 to 600 seconds (by 5 seconds)
Time
The recommended value for this product is 30 seconds or longer.
If the response is too fast with the factory default setting (5 seconds),
change the signal output response time as needed.
14
Display item
Item
SS
SS
Trans.
OFF
SS
SS
Trans.
Setting range
Factory default
Unit
mg/L SS mg/L
No unit
cm
- OFF
No unit
mg/L
cm
Factory default
setting
5 seconds
setting