Table of Contents
Advertisement
[8] Attach the sensor unit to the base.
Press the excess wire back into to the pole while attaching the unit.
[9] Perform the steps in P.13 through 16 "4-2 Setting Verification and Adjustment", "4-3 Calibration", and
"4-4 Detection Area Check".
[10] Put the front cover on the top of the base first, and attach it while spreading it open and pushing down
the front cover.
[11] Tighten the front cover retaining screw.
Attach the front cover while spreading it open
and pushing down the bottom of the cover.
-12-
Advertisement
Table of Contents
