Table of Contents
Advertisement
[5] Detection Area Check: Go to P.15
Verify the detection area. If needed, change the installation angle of the unit and/or sensing distance
setting.
* Once the installation condition such as the angle is modified, perform the calibration again.
OVS-01CC
Sensitivity
VALUE
Maximum Range (m)
1
2
5
6
Output1
N.O.
N.C.
[6] System Operation Check: Go to P.16
Check the whole system operation that is connected to the sensor.
[7] Detailed Setting adjustment (if needed): Go to P.18
Change the parameter of settings if necessary after the
system operation check.
[8] Attaching Front Cover: Go to P.12
Attach the front cover, and the installation is complete.
Maintenance Cleaning
NOTE
If the unit becomes dirty, lightly wipe sensor with a soft brush or cloth.
If not cleaned yet, use a neutral detergent to clean the sensor.
1
2
3
4
5
Standby
Area Check
3
4
Detection
Calibration
7
8
Output2
Calibration Area Check
N.O.
N.C.
Do not use chemicals such as alcohol.
●
Do not apply high-pressure water. It may result in a failure or fire.
●
OVS-01CC
Sensitivity
VALUE
Maximum Range (m)
1
5
Output1
N.O.
N.C.
-9-
1
2
3
4
Standby
Area Check
2
3
4
Detection
Calibration
6
7
8
Output2
Calibration Area Check
N.O.
N.C.
5
Advertisement
Table of Contents
