Mikroprog Suite™ For Arm® Software - mikroElektronika mikromedia for STM32 Manual

mikroProg Suite
On-board mikroProg™ programmer requires special programming software called mikroProg
Suite™ for ARM®. This software is used for programming of all supported microcontroller
families with ARM® Cortex™-M3 and Cortex™-M4 cores. Software has intuitive
interface and SingleClick™ programming technology. To begin, first locate the
installation archive on the Product DVD:
20122011
www.mikroe.com
DVD://download/eng/software/development-tools/arm/mikroprog/
mikroprog_suite_for_arm_v110.zip
Copyright ©2011 Mikroelektronika.
All rights reserved. Mikroelektronika, Mikroelektronika logo and other
After downloading, extract the package and double click the executable
Mikroelektronika trademarks are the property of Mikroelektronika.
All other tradmarks are the property of their respective owners.
Unauthorised copying, hiring, renting, public performance and
broadcasting of this DVD prohibited.
setup file, to start installation.
Quick Guide
Click the Detect MCU button
01
Click the Read button
02
button
to save it to target HEX file.
If you want to write the HEX file to the microcontroller, first make sure to load the target
03
HEX file. You can drag-n-drop the file onto the software window, or use the
open Browse dialog and point to the HEX file location. Then click the
programming.
for ARM
™
in order to recognize the device ID.
to read the entire microcontroller memory. You can click the
Software
®
Figure 3-11:
mikroProg Suite for ARM®
™
window
Save
Load button
Write button
to begin
Page 19
to