Programming With Mikroprog™ Programmer - mikroElektronika mikromedia for STM32 Manual

Programming with mikroProg
The microcontroller can be programmed with external
The mikroProg™ programmer is connected to the development system via the CN5 (JTAG) connector. You can choose between two ways to
program microcontrollers , Figure 3-14:
Via JTAG interface
01
Via Serial wire debug (SWD) interface
02
NOTE:
Before attaching the programming connector, you have to solder the provided 2x5 male header to the JTAG pads (CN5)
™
mikroProg™ for STM32® programmer
Page 18
programmer
mikroProg Suite™ for ARM®
and
programmer with mikroICD™
hardware In-Circuit Debugger.
It supports over 180 ARM® Cortex™
M3 and Cortex™ M4 microcontrollers from
STM32® family. Outstanding performance, easy
operation and elegant design are it's key features.
software.
Figure 3-10:
Connecting
mikroProg™ to
mikromedia™
mikroProg™
is a fast USB 2.0