Mikroprog Suite For Arm Software - mikroElektronika CLICKER 2 STM32 Manual

mikroProg Suite
On-board mikroProg programmer requires special programming software called mikroProg Suite
™
for ARM . This software is used for programming of all supported microcontroller families with
®
ARM Cortex -M3 and Cortex
® ™
programming technology. To begin, first locate the installation archive on the link bellow:
http://www.mikroe.com/downloads/get/1809/mikroprog_suite_for_arm.zip
After downloading, extract the package and double click the executable setup file, to start installation.
Quick guide
Click the Detect MCU button in order to recognize the device ID.
01
Click the Read button to read the entire microcontroller memory.
02
You can click the Save button to save it to the target HEX file.
If you want to write the HEX file into the microcontroller, first
03
make sure to load the target HEX file using the Load button.
Then click the Write button to begin programming.
Click the Erase button to clear the microcontroller memory.
04
for ARM
™
-M4 cores. The software has an intuitive interface and SingleClick
™
software
®
Figure 3-10:
mikroProg Suite
for ARM window
®
Page 16
™
™
™