Sub-Zero 542 Installation Instructions Manual page 7

I II II
I IIIIII I I
iF'NSTALLATION
.,qSTRUCTIONS
-,-]_
,4) Remove Iouvered grille.
Refer to step 7.
B) Open the door(s) and
attach template provided with
panel grille installation kit. The
template center hold must be
aligned with the grille screw
hole and you must fasten from
the top down with the screw
you removed in step A. See
Figure 20.
(7,)With template in place, drill
1/8" pilot holes in the end holes
of the template. See Figure 20.
Enlarge pilot holes by drilling
3h6" finished holes; After
drilling holes, remove template
and discard. Keep screw'fer
later installation.
11" GRILLE ONLY
532 & SN
11" THRU T$" GRILLE
ALL OTHER MODELS
SCREW GROMMET
P_ ,l-:z-o.-0
UPPER G_LLE SCREW
pin .1_,o.o, 3-o
t
i
LOWER GRILLE SCREW
Figure 20
D) Install screw grommets in
properly labeled holes in
Figure 20 in the shroud
assembly.
E) Attach the outer grille
frame to the shroud assembly
by inserting the two upper
grille screws into their proper
holes and with door(s) open
install the lower three grille
screws as shown in Figure 20
and Figure 10.
F) Refer to Model 590 grille
installation, steps B through E.
on this page for the remainder
of the assembly. ....
MODEL 590
(STANDARD FEATURE)
EA GRILLE PANEL SIZE
Grille Size Panel Size
10x48 83/16 x 463/16
11 x 48
93/16
x 463116
12 x 48 103/16X 463/16
13 x 48 113/16X 463/16
14x48 123/16X 463/16
15 x 48 133/16x 463116
A) Remove the inner grille
panel assembly (refer to
step 7).
B) Remove the top two corner
screws and pull away the top
frame. See Figure 21.
Figure 21
C) Slide panel into position
in grille frame as shown in
Figure 22.
NOTE: When using _/4" or
less, a filler is necessary.
Figure 22
D) Reattach the top frame by
reinstalling the two top corner
screws.
E) InstaEinner grille panel
assembly back onto product
(refer to step 7).
7