Constant Setup And Initialization; Constant Selection/Initialization (N01) - YASKAWA VS mini J7 Series Instruction Manual

Constant Setup and Initialization

Constant Selection/Initialization (n01)

The following table lists the data that can be set or read when n01 is set.
Unused constants between n01 and n79 are not displayed.
n01 Setting
0
1
5
6
7
8
9
* 1. Excluding setting-disabled constants.
* 2. Refer to page 70.
NOTE
44
Constant That Can Be Set
n01
*1
n01 to n79
*1
n01 to n79
(Run command can be received in Program mode.)
Fault history cleared
Not used
Initialize
Initialize (3-wire sequence)
appears on the display for one second and the set data
returns to its initial values in the following cases.
1. If the set values of input terminal function selection 2 to 5
(n36 to n39) are the same.
2. If the following conditions are not satisfied in the V/f pat-
tern setting:
Max. Output Frequency (n09)
For details, refer to Adjusting Torque According to Appli-
cation (V/f Pattern Setting) on page 45.
3. If the following conditions are not satisfied in the jump
frequency settings:
Jump Frequency 2 (n50) ≤ Jump Frequency 1 (n49)
Constant That Can Be Referenced
n01 to n79
*2
≥ Max. Voltage Output
Frequency (n11)
> Mid. Output Frequency
(n12)
≥ Min. Output Frequency
(n14)