Power Dispatch; System Protection Parameters Setup - YASKAWA PVI 36TL Installation And Operation Manual

Table of Contents

PVI 36TL Installation and Operation Manual (Rev H)

interface if the MPPT scanning succeeds, or remain on the "MPPTScan menu"

interface if the scanning fails.

(7) Configure the network address in the "7 NetConfig" menu.

Move the cursor to the menu, press ENT and set up the parameters by UP and

DOWN. Note if you have a daisy chain you cannot have two devices (inverters or

other Modbus devices) with the same network ID.

INSTRUCTION:

Move the cursor to the corresponding menu to set up the parameters,

and the number will flash after pressing ENT. Use UP and DOWN to

adjust the parameters.

4.4.5 Power dispatch

Move the cursor to "5 Dispatch" in the main interface and press ENT to go to the

following interface (Figure 4.13):

Remote power dispatch: The "ActivePower" and "PowerFactor" can be adjusted

remotely by software.

Press DOWN and ENT at the same time in the main interface and enter the

password (UP -> DOWN -> UP -> DOWN) to access the system protection parameters

setup menu. This menu includes 6 submenus: "1 SysPara", "2 Restart", "3 Recover", "4

ClrErrRecd" and "5 Stdset", as shown in Figure 4.14.

DOCR-070588-H

5 Dispatch

Figure 4.13 Active Power and PowerFactor

ActivePower(%)

100.0

PowerFactor

1.000

Page 81 of 120

Table of Contents