6. Programming Features
Factory settings of the constants are shaded in the tables.
After wiring is complete, be sure to make the following settings before oper-
ation.
Hardware
Make the following settings before the Inverter is turned ON.
Sequence input signal (S1 to S5) polarity selection
Voltage reference / current reference input selection of
control circuit terminal FR
Software (Constant)
Environment
setting
Basic
characteristics
and frequency
reference setting
Motor protection
Countermeasure
for noise and
leakage current,
Using an optional
braking resistor
Item
Item
Constant Selection / Initialization (n01)
RUN Command Selection (n02)
Frequency Reference Selection (n03)
Stopping Method Selection (n04)
V/f pattern setting (n09 to n15)
Acceleration Time 1 (n16),
Deceleration Time 1 (n17)
Frequency Reference 1 to 8
(n21 to n28)
Motor Rated Current (n32)
Electric Thermal Motor Protection
Selection (n33)
Carrier Frequency Reference (n46)
6. Programming Features
Ref.
115
75
Ref.
44
49
50
67
45
55
51
81
81
64
43