Table of Contents
Advertisement
2.3 Fitting and electrical connection
Fitting and connecting a device for device variants 1gang and 3gang
Figure 2: Device fitting using the example of a push button sensor 3 basic 1-gang
(5) Flush-mounted bus coupling unit 3 with supporting frame
(6) Design frame
(7) Pushbutton sensor cover
(8) Fit bolt for anti-theft protection (included with the pushbutton sensor cover)
(10) Inscription panel
(11) Rocker cover
The pushbutton sensor cover must be plugged onto a flush-mounted bus coupling unit 3. Anti-
dismantling protection is provided by screwing to the supporting frame of the bus coupling unit.
o
Connect the bus coupling unit (5) with the KNX/EIB bus cable and fasten in place in an
appliance box.
o
Remove the rocker covers (11) and inscription panels (10) from the pushbutton sensor
cover (7).
o
Position the design frame (6) in front of the bus coupling unit and carefully plug the
pushbutton sensor cover into the bus coupling unit.
o
Screw the pushbutton sensor cover to the supporting frame of the bus coupling unit. Use
the screw (8) provided.
o
If necessary, label the inscription signs. Optionally the separately available labelling sheets
(see Accessories) can be used.
o
Finally, mount the rocker covers together with the labelling panel by snapping them on.
Order No. 5111 00
Order No. 5112 00
Order No. 5113 00
Installation, electrical connection and operation
Page 7 of 23
Advertisement
Table of Contents
