Notes On Software - Gira 5112 00 Product Documentation

4.2.2 Notes on software

ETS project design and commissioning
For configuration and commissioning of the device, ETS3.0 from Version "d" Patch "A" onwards
or ETS4 is required. Through use of these ETS version, advantages are gained with regard to
the programming process and the parameter presentation.
The necessary product database is offered in the *.VD4 format.
Device combination with a bus coupling unit 3
The pushbutton sensor must be plugged onto the flush-mounted bus coupling unit 3 (see
Accessories). Only the combination of this bus coupling unit and the pushbutton sensor cover
results in a functional unit. The device configuration is not programmed into the bus coupling
unit. Therefore it is possible to operate devices that have already been put into operation on any
desired third-generation bus coupling units. This can simplify commissioning significantly,
because programming of the devices no longer has to be performed on the same bus coupling
unit that the pushbutton sensor will later be plugged onto in the building.
i Plugging the pushbutton sensor onto a flush-mounted bus coupling unit 1 or 2 (older
generation) is not possible in some cases, and generally not intended, and as a result the
device combination will not function.
Order No. 5111 00
Order No. 5112 00
Order No. 5113 00
Software "Push button sensor 3 basic"
Notes on software
Page 15 of 23