Table of Contents
Advertisement
2.4 Commissioning
Loading the physical address and application software
The commissioning of the device is basically confined to programming of the physical address
and the application data with the ETS.
Project planning and commissioning of the device using the ETS 3.0d with Patch A or newer
versions.
The device is connected and ready for operation.
An appropriate device must be created and configured in the ETS project.
Figure 4: Arrangement of the programming button and LED on the front of the device
The programming button is located on the front of the device behind a labelling panel (Figure 4).
Before final fitting of the rocker covers, the physical address has to be loaded into the device.
o
Detach the control surface over the programming button/LED, if the rocker covers are
already fitted.
o
Activating Programming mode: press the programming button (12).
The programming LED (13) lights up red.
o
Program the physical address with the help of the ETS.
The programming LED goes out.
o
Load the application data into the device using the ETS.
o
Mount control surface(s).
i If the device was programmed with incorrect application data, then backlighting of the
labelling field flashes slowly. In this case, the device will not function after start-up.
Order No. 5111 00
Order No. 5112 00
Order No. 5113 00
Installation, electrical connection and operation
Page 10 of 23
Advertisement
Table of Contents
