Manually Adjusting The Field Size; Preparation - RAYLASE AXIALSCAN Manual

3-axis subsystems for laser beam deflection

Hide thumbs

Table Of Contents

Table of Contents

Chapter 5

5.6

The 3-axis laser beam subsystem can be adjusted to different field sizes as follows. The field

sizes that can be set are listed in the data sheet. If you want to set a different field size, you

must consult RAYLASE for assistance.

5.6.1

o Load the correction file corresponding to the desired operating field size.

Make sure that you use the following identification code:

AXIALSCAN

The following identification code is used for AXIALSCAN type subsystems:

Type

AXIALSCAN

│

Aperture of associated deflection unit [mm]

│

Coating code

│

└─ └─ └─ └────────└── └

XX-XX-XX_XXXX-XXXXxxx_XXXX.gcd

FOCUSSHIFTER

The following identification code is used for FOCUSSHIFTER type subsystems:

Type

FOCUSSHIFTER

│

Aperture of associated deflection unit [mm]

│

Coating code

│

└─ └─ └─ └──

XX-XX-XX_XXX.gcd

o Create all electrical connections for the power supply and for control of the 3-axis subsys-

tem ( page 9, Special hazards caused by mirrors made of beryllium).

o For details of connecting the deflection unit to a RAYLASE control card and operation with

RAYLASE software, refer to the corresponding manuals.

In general there are no special correction files for Focusshifter. The standard 2-axis correction files are used.

For using weldMARK in combination with FOCUSSHIFTER a special configuration file has to be generated in order to

compensate for different object sizes at different z-position.

RAYLASE 3-Axis Subsystems for Laser Beam Deflection

For subsystems with manual field size adjustment only