Section 9 Product Specifications - Banner ES-TA-3F1 Operating Instructions Manual

E-Stop Safety Module –
SECTION 9 – Product Specifications
Supply Voltage and Current
Supply Protection Circuitry
Output Configuration
Output Response Time
Input Requirements
Status Indicators
Enclosure
Mounting
Vibration Resistance
Operating Temperature
Dimensions
Certifications
WARRANTY: Banner Engineering Corp. warrants its products to be free from defects for one year. Banner Engineering Corp. will repair or
replace, free of charge, any product of its manufacture found to be defective at the time it is returned to the factory during the warranty period.
This warranty does not cover damage or liability for the improper application of Banner products. This warranty is in lieu of any other warranty
either expressed or implied.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Model ES-TA-3F1
24V dc ±15% at 450mA maximum; 10% maximum ripple
Protected against transient voltages and reverse polarity
Outputs (K1 and K2): two redundant (i. e. total of four) safety relay (forced-guided) contacts
Contact ratings:
Maximum voltage: 250V ac or 250V dc
Maximum current: 4A ac or dc (resistive load)
Maximum power: 1000VA, 20 watts
Mechanical life: 10,000,000 operations
Electrical life: 100,000 at full resistive load
NOTE: Transient suppression is recommended when switching inductive loads. Install suppressors across
load. Never install suppressors across output contacts (see Warning on page 5).
25 milliseconds maximum
Emergency stop switch must have two normally closed contacts each capable of switching 20 to 150mA
@ 12 to 18V dc.
Reset switch must have one normally open contact capable of switching 20 to 150mA @ 12 to 18V dc.
Master Stop Control (MSC) Element monitor contacts must be capable of switching 20 to 250 mA @ 12 to 18V dc
28 green LED indicators:
Power ON ES1-A ES3-A
K1 energized ES1-B ES3-B
K2 energized ES2-A ES4-A
ES2-B ES4-B
1 Bi-color red/green LED indicator for Bus Status
1 Amber LED Indicator for MAC ID
Size: See Figure 2, page 5
Material: polycarbonate. Rated NEMA 1, IEC IP20
Mounts to standard 35 mm DIN rail track. Safety Module must be installed inside an enclosure rated NEMA 3,
IEC IP54, or better.
10 to 55Hz @ .35mm displacement per IEC 68-2-6
0° to 50°C (+32° to 122°F)
See diagram, page 10
R
ES5-A ES7-A ES9-A
ES5-B ES7-B ES9-B
ES6-A ES8-A ES10-A
ES6-B ES8-B ES10-B
Monitor-1 Reset
Monitor-2
Monitor-3
Monitor-4