Switch Power; Specifications - Banner DX80DR9M-HB1 Manual

SureCross MultiHop Data Radio Module

Switch Power

I/O Group
Switch Power (all)

Specifications

Radio
Radio Range
900 MHz: Up to 9.6 kilometers (6 miles) *
2.4 GHz: Up to 3.2 kilometers (2 miles) *
Radio Transmit Power
900 MHz: 30 dBm conducted (up to 36 dBm EIRP)
2.4 GHz: 18 dBm conducted, less than or equal to 20
dBm EIRP
900 MHz Compliance (1 Watt Radios)
FCC ID UE3RM1809: This device complies with FCC
Part 15, Subpart C, 15.247
IC: 7044A-RM1809
2.4 GHz Compliance
FCC ID UE300DX80-2400 - This device complies with
FCC Part 15, Subpart C, 15.247
ETSI/EN: In accordance with EN 300 328: V1.7.1
(2006-05)
IC: 7044A-DX8024
Spread Spectrum Technology
FHSS (Frequency Hopping Spread Spectrum)
* With the 2 dB antenna that ships with the product. High-gain an-
tennas are available, but the range depends on the environment
and line of sight. To determine the range of your wireless network,
perform a Site Survey.
Notice: This equipment must be professionally installed. The output power must be limited, through the use of firmware or a hardware
attenuator, when using high-gain antennas such that the +36 dBm EIRP limit is not exceeded.
Inputs
Discrete Inputs
Rating: 3 mA max current at 30V dc
Sample Rate: 40 milliseconds
ON Condition: Less than 0.7V
OFF Condition: Greater than 2V or open
Analog Inputs
Rating: 24 mA
Impedance: 100 Ohms
Sample Rate: 1 second
Accuracy: 0.1% of full scale +0.01% per °C
Resolution: 12-bit
To verify the analog input's impedance, use an Ohm meter to
measure the resistance between the analog input terminal (AIx)
and the ground (GND) terminal.
P/N 154365 Rev. C
Continuous Voltage
0
www.bannerengineering.com - tel: 763-544-3164
Default Output Voltage
0
General
Power*
Requirements: +10 to 30V dc (For European applica-
tions: +10 to 24V dc, ± 10%). (See UL section below
for any applicable UL specifications) or 3.6 to 5.5V dc.
Supply must tolerate loads in excess of 1000 mA.
Interface
One red/green LED
One push button
Antenna Connection
Ext. Reverse Polarity SMA, 50 Ohms
Max Tightening Torque: 0.45 N·m (4 lbf·in)
* For European applications, power the DX80 from a Limited Pow-
er Source as defined in EN 60950-1.
Outputs
Discrete Output Rating (MultiHop NMOS)
Less than 1 A max current at 30V dc
ON-State Saturation: Less than 0.7V at 20 mA
Discrete Output ON Condition
Less than 0.7V
Discrete Output OFF Condition
Open
Hold Last Voltage Ena-
ble
OFF
9