Banner DX99N9X1S2N0M2X0D2 Manual

SureCross DX99 FlexPower Node (Metal
Housing)
Datasheet
®
The SureCross wireless system is a radio frequency network with integrated I/O that can operate in most environments
and eliminate the need for wiring runs. DX99 wireless networks are formed around a Gateway, which acts as the wireless
network master device, and one or more Intrinsically Safe Nodes.
For additional information, updated documentation, and accessories, refer to Banner Engineering's website,
www.bannerengineering.com/surecross.
Model
DX99N9X1S2N0M2X0D2
DX99N2X1S2N0M2X0D2
DX99N9X1S2N0M2X0D1
DX99N2X1S2N0M2X0D1
Model
DX99N9X1S2N0V2X0D2
DX99N2X1S2N0V2X0D2
DX99N9X1S2N0V2X0D1
DX99N2X1S2N0V2X0D1
Internal antenna models are also available. For more information, contact your local Banner Engineering Corp.
representative. Integrated battery models are also available without batteries. If you purchase a model without the
battery, Banner Engineering recommends using the XENO XL-205F battery or equivalent. For DX99 models, only a XENO
XL-205F battery is certified.
WARNING: Not To Be Used for Personnel Protection
Never use this device as a sensing device for personnel protection. Doing so could lead to
serious injury or death. This device does not include the self-checking redundant circuitry necessary
to allow its use in personnel safety applications. A sensor failure or malfunction can cause either an
energized or de-energized sensor output condition.
Original Document
142497 Rev. L
• Wireless industrial I/O device with two selectable discrete inputs and two
analog inputs
®
• FlexPower technology driven by one lithium primary battery integrated
into the housing
• DIP switches for user configuration
• Frequency Hopping Spread Spectrum (FHSS) technology and Time
Division Multiple Access (TDMA) control architecture ensure reliable data
delivery within the unlicensed Industrial, Scientific, and Medical (ISM)
band
• Transceivers provide bidirectional communication between the Gateway
and Node, including fully acknowledged data transmission
• Lost RF links are detected and relevant outputs set to user-defined
conditions
• DX99 Metal housings are certified for use in Class I, Division 1, Groups A,
B, C, D; Class II, Division 1, Groups E, F, G; Class III, Division 1; and
Zone 0 (Category 1G) and Zone 20 (Category 1D) when properly installed
in accordance with the National Electrical Code, the Canadian Electrical
Code, or applicable local codes/regulations
Frequency Boost Voltage
900 MHz ISM Band
2.4 GHz ISM Band
900 MHz ISM Band
2.4 GHz ISM Band
Frequency Boost Voltage
900 MHz ISM Band
2.4 GHz ISM Band
900 MHz ISM Band
2.4 GHz ISM Band
30 December 2014
I/O
Discrete Mode
18 V
Inputs: Two selectable discrete
Switch Power: Two, Configurable
Analog Mode
Inputs: Two selectable discrete, two 0 to 20 mA
10 V
analog
Switch Power: One, Configurable
I/O
Discrete Mode
18 V
Inputs: Two selectable discrete
Switch Power: Two, Configurable
Analog Mode
Inputs: Two selectable discrete, two 0 to 10V
10 V
analog
Switch Power: One, Configurable
142497