Section 3 Mounting The E-Stop - Banner ES-TA-3F1 Operating Instructions Manual

7.4 mm
(0.29")
60.8 mm
(2.40")
7.1 mm
(0.28")
Figure 2. ES-TA-3F1 Safety Module dimensions
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
SECTION 3 – Mounting the E-Stop Safety Module
Mount the ES-TA-3F1 E-Stop Safety Module inside a lockable enclosure which has a
minimum rating of NEMA3 (IP54). The model ES-TA-3F1 E-Stop Safety Module is not
designed for exposed wiring. It is the user's responsibility to house the Safety
Module in an enclosure with NEMA 3 (IEC IP54). For security reasons, the key to the
lockable enclosure should be in the possession of a Qualified Person (see section 5.1,
Security Protocol).
The Safety Module housing may be mounted onto standard 35 mm DIN rail or may be
mounted directly to the backplate of the lockable enclosure, using the supplied
hardware. Leave a minimum 1 cm (1/4") gap between the Safety Module housing and
adjacent housings, to allow room for potential board replacement at a later date.
The ES-TA-3F1 E-Stop Safety Module should be configured before initial checkout and
use (see section 4.4 and 4.5).
149.0 mm
(5.87")
134.2 mm
(5.28")
DIN Mounting Tab
(Supplied)
E-Stop Safety Module –
110.0 mm
(4.33")
Combo Head (Phillips/Slotted) Screws
M3.5 x 0.6 mm x 14 mm (2) (#6 x 0.5" equivalent) (Supplied)
M3.5 mm Washers (2) (#6 equivalent) (Supplied)
M3.5 mm x 0.6 mm Nuts (2) (#6 equivalent) (Supplied)
Recommended torque is
16-20 in-lbs on mounting screws
35.0 mm
(1.38")
DIN Mounting Slot
Slot for Screws (2)
M3.5 x 0.6 mm (2)
Model ES-TA-3F1
75.0 mm
(2.93")