Table of Contents
Advertisement
Option EXM, External Mixing Upgrade Kit, Serial Prefix = MY/SG/US5233 or ≥ MY/SG/US5606
Installation Procedure
Analyzer Information
1. Connect a power cord to the analyzer and turn on the analyzer.
2. After the analyzer has completed turning on, press System, Show, System. Make note of the
following information from the Show System screen:
Product Number: _____________
Serial Number: ______________
Instrument S/W Revision: ______________
3. Check for the presence of one of the following options listed below in the Show System. Put a
check mark or "X" after the option listed below that appears in the Show System menu.
N9020A-B40_____
N9020A-CR3_____
N9020A-CRP_____
N9020A-DP2_____
N9020A-MPB_____
N9020A-BBA_____
4. On the analyzer, press System, Show, Hardware. Note the Part #, Matl Rev, Rev, OF Rev, and
Hw Id of the Front End Controller and Front End in the table below.
Assembly Name
Front End Controller
Front End
5. Refer to the data in
the installation of this kit. This kit is to be installed only on N9020A signal analyzers.
6. Refer to the data in
serial number) is something other than either MY/SG/US5233 or ≥ MY/SG/US5606 do not
proceed with the installation of this kit. This kit is to be installed only on N9020A signal
analyzers with serial prefix MY/SG/US5233 or ≥ MY/SG/US5606.
7. Refer to the data in
steps required to remove and replace the front panel assembly.
8. Refer to the data in
already present, the EFEC is already installed and you do not need to perform the Replace
Front End Controller procedure.
6
Part #
Matl Rev
step 2
above. If the Product Number is not N9020A, do not proceed with
step 2
above. If the Serial Number prefix (the first six characters of the
step 3
above. If option N9020A-BBA is present, there will be additional
step 3
above. If option N9020A-B40, N9020A-MPB and/or N9020A-DP2 is
Rev
OF Rev
Installation Note N9020-90229
Hw Id
Advertisement
Table of Contents
