Adding And Programming Additional Accessories - Overhead door INFINITY 2000 Installation, Programming, Operating Manual

Programming Additional Accessories
The original wireless wall console and light kits are pre-programmed from the factory. However, if adding an
additional WIRELESS WALL CONSOLE or LIGHT FIXTURE to this unit or either original require reprogramming
for any reason, follow the instructions below.
• WIRELESS WALL CONSOLE
1. Press and hold the SET/PRGM button on the opener for 2-5 seconds.
• The ROUND LED will turn BLUE. Release button.
• The LONG LED will then flash PURPLE.
2. Press wall console main button 3 times slowly. Door should run.
LIGHT FIXTURE INCLUDED WITH OPENER:
1. Power up Wall Mount Opener.
2. Power LIGHT FIXTURE.
3. LIGHT FIXTURE will flash and beep.
4. LIGHT FIXTURE is now paired to opener and will operate as normal.
INSTALLING ADDITIONAL LIGHT KITS: (UP TO 3 LIGHT KITS TOTAL)
1. Press and hold the SET/PRGM button on the opener for 2-5 seconds.
• The ROUND LED will turn BLUE. Release button.
• The LONG LED will then flash PURPLE.
2. Press button on the LIGHT FIXTURE 1 time.
3. LIGHT FIXTURE will flash and beep.
4. LIGHT FIXTURE is now paired to opener and will operate as normal.
• This portable luminaire has a polarized plug (one blade is wider than the other) as a feature to reduce the risk of electric
shock. This plug will fit in a polarized outlet only one way.
• If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician.
• Never use with an extension cord unless plug can be fully inserted.
• Do not alter the plug.
WARNING
!
IMPORTANT SAFETY INSTRUCTIONS
31