Programming Vehicle Controls - Overhead door INFINITY 2000 Installation, Programming, Operating Manual

PROGRAMMING VEHICLE CONTROLS

Programming HomeLink® System
Step 1 Clear HomeLink
Clear HomeLink by pressing and holding down the first and third buttons until the indicator on the
HomeLink blinks slow and then fast for 22 seconds; then release both buttons.
NOTE: Clearing the HomeLink will remove all previously programmed garage door openers.
Step 2 Train HomeLink to the Remote
Choose the button on the HomeLink that will be used to open the door.
NOTE: Hold the Remote two inches from the HomeLink button.
Hold down the remote button. While holding, press and hold the chosen HomeLink button.
Hold down both buttons until the indicator on the HomeLink blinks slow then fast. Once it blinks, release
both buttons.
Step 3 Program HomeLink to the Opener
(Place opener into programming mode)
A. Press and hold the PRGM button on the opener until the round blue LED is ON. Release the button. The long purple LED will
begin flashing.
B. Press the chosen HomeLink button for two seconds and release. Press that same button again for two sec-
onds and release. The both LEDs will flash blue and then turn off.
C. Press the HomeLink button a few more times until door moves.
NOTE: For additional instructions, see the motor vehicle manual, www.homelink.com or visit www.overheaddoor.com
PUTTING OPENER INTO PROGRAMMING MODE:
1. Press and hold the SET/PRGM button on the opener for
2-5 seconds.
• The ROUND LED will turn BLUE. Release button.
LONG
• The LED will then flash PURPLE.
2. Complete programming steps.
PRESS
&
RELEASE
Solid Blue
NOTE: The openers LEARN LED will time out in 30 seconds.
Programming must be completed within 30 seconds.
Flashing Purple
(ABBREVIATED)
23