Clearing Remote/Accessory Memory - Overhead door INFINITY 2000 Installation, Programming, Operating Manual

SPECIAL INSTALLATION INFORMATION
CLEARING MEMORY OF REMOTE CONTROLS
NOTE: Clearing memory of remotes from the powerhead will
clear ALL programmed remotes, wireless keypads and vehicle
transmitters. The opener will no longer recognize any signal
from any remote device, including a missing remote device. This
does not include the OHD Anywhere® or Wireless Wall Console.
All remaining (or recovered) remotes, vehicles and wireless
keypads MUST be reprogrammed.
1. Press and hold the SET/PRGM button on the
opener for 2-5 seconds.
• The ROUND LED will turn BLUE. Release button.
• The LONG LED will then flash PURPLE.
2. Press and hold the UP & DOWN buttons 2-5
seconds until both LEDs turn BLUE then release.
Both LEDs will turn off indicating that all remotes
have been erased.
3. Press any remote button.
The opener should NOT run.
CLEARING MEMORY OF WIRELESS WALL CONSOLE
1. Press and hold the SET/PRGM button on the
opener for 2-5 seconds.
• The ROUND LED will turn BLUE. Release button.
• The LONG LED will then flash PURPLE.
2. Press and hold the UP & DOWN buttons 10+
seconds until both LEDs turn GREEN then release.
Both LEDs will turn off indicating that all Wireless
Wall Consoles have been erased.
3. Press WALL CONSOLE button.
The opener should NOT run.
28
1. Enter Programming Mode
Solid Blue
2. Press and Hold UP & DOWN Buttons 2-5 seconds
Release when
LEDs turn BLUE
3. Test Remote
1. Enter Programming Mode
Solid Blue
2. Press and Hold UP & DOWN Buttons 10+ seconds
Release when
LEDs turn GREEN
3. Test Wireless Wall Console
Flashing Purple
Flashing Purple