Overhead door INFINITY 2000 Installation, Programming, Operating Manual page 26

PROGRAMMING VEHICLE CONTROLS
Programming Car2U ® System
Step 1 Clear Car2U to default settings
The default setting for the Car2U system is:
• Button 1 = Overhead Door® & Genie® Manufactured Openers
• Button 2 = LiftMaster® Manufactured Openers
• Button 3 = Wayne Dalton® Manufactured Openers
A. Press and hold buttons 1 and 3 for 22 seconds or until all three LEDs begin to flash.
B. Release both buttons. The Car2U system is now set to the Factory Default settings
NOTE: Clearing the Car2U remote will remove all previously programmed garage door openers.
Step 2 Program Car2U to the Opener
(Place opener into programming mode)
A. Press and hold the PROGRAM button on the opener until the round blue LED is ON—release the button.
The long purple LED will begin flashing.
B. Press the designated Car2U button for two seconds and release. Press that same button again for two
seconds and release. The long LED will flash blue and then turn off.
C. Press the Car2U button a few times more until door moves.
Step 3 Changing Factory Default Button for a Genie® or Overhead Door™ Opener
A. Press and hold buttons 1 & 3 for ONE SECOND and release all three LEDs will light solid red.
B. Press and hold the button (2 or 3) to change it to a Genie® or Overhead Door® Opener, corresponding LED
will flash. While continuing to hold that button, press and release button 1. Press and release button 1 again.
C. Release the button being held in step B and wait for the LED to stop flashing. This button is now set. Repeat
Step 2 for second Opener.
24
PUTTING OPENER INTO PROGRAMMING MODE:
1. Press and hold the SET/PRGM button on the opener for
2-5 seconds.
• The ROUND LED will turn BLUE. Release button.
LONG
• The LED will then flash PURPLE.
2. Complete programming steps.
PRESS
&
RELEASE
Solid Blue
NOTE: The openers LEARN LED will time out in 30 seconds.
Programming must be completed within 30 seconds.
Flashing Purple
(ABBREVIATED)