Table of Contents
Advertisement
INSTALLING OPTIONAL ACCESSORIES
DRAWBAR PLATE (Required with Installation of Operator)
1. Center the Drawbar plate on the Center Stile in the
middle of the Door or wherever the Operator will be
installed. For Insulated doors install the drawbar
plate at the center of the door.
2. Install the Drawbar plate using Screws provided at
the Four corner locations.
3. If a Strut is installed on the Door, the drawbar plate
should be attached underneath the strut.
4. Drawbar plate is required on steel back insulated
doors (323, 329). It is optional on a pan door.
LOCK INSTALLATION
1. Center lock rod in track cutout. Retract lock rod and
position so that end of lock rod extends 1/2" beyond
edge of door section in unlocked position. See
Figure 2.
2. Mark 4 holes indicated and drill 1/8" holes.
3. Attach lock assembly with four 1/4"-14 x 5/8"
self-extruding screws.
For optional lock attachment, see page 23.
CUT ALONG THIS LINE
FIGURE 3
LOCK SECTION HOLE PATTERN TEMPLATE
DRAWBAR PLATE
TRACK
END STILE
22
AB POINT SCREWS
STRUT (If required)
FIGURE 1
LOCK ROD
SELF EXTRUDING
SCREWS
LOCK
ASSEMBLY
FIGURE 2
Advertisement
Table of Contents
