Programming; Travel Limits; Closing Garage Door (Down Limit) - Overhead door Standard Drive 650 Operation & Maintenance Manual

Programming Information

TRAVEL LIMITS

NOTE: If bullet has NOT been engaged to carriage, do so now. See page 12.
NOTE: Before setting limits confirm wall console red indicator
backlight in ON. If not illuminated, check for correct wiring or the
Sure-Lock switch may be activated. (On selected units.)
ORIENTATION
Standing under the opener's powerhead – facing the door – looking up –
this is the view you will see of the programming buttons and LEDs.
Enters into and selects programming menus.
Multi-function; move door during programming
and advance through menus.
NOTE: While setting limits, the powerhead has a 30 second time-out.
You have 30 seconds to execute each step. If you see two solid red
or flashing LEDs on the Powerhead, you have run-out of time and
must go back to the beginning of the step and start over, You can restart
as many times as necessary to complete each step.
• Just remember—the pointed end
of the button (like an arrowhead)
points in the direction the carriage
will move when that button
is pushed.
(Travel Limits continued next page)
7