Programming Accessories; Wireless Keypad - Overhead door INFINITY 2000 Installation, Programming, Operating Manual

PROGRAMMING ACCESSORIES

QuickView Single Door setup.
Please see complete instructions that accompany keypad
Activate keypad by opening battery
compartment and pull protective
tab. Reinstall compartment door
Program Keypad before mounting.
STEP 1) PROGRAMMING A PIN NUMBER (Single Door)
Program the keypad for the first time* with a Personal
Identification Number (PIN). This PIN must be 3 to 8 digits.
1. Ensure number pad back lighting is off.
2. Press 3-5-7 in sequence.
3. Press PROGRAM key. LED will blink once per second.
4. Enter a PIN number (3-8 digits).
5. Press PROGRAM key. LED will blink twice and shut off.
STEP 2) PROGRAMMING THE KEYPAD TO 1 OPENER
1. Place garage door opener into PROGRAMMING MODE.
2. Ensure number pad back lighting is off.
3. Enter the PIN number on keypad.
4. Press the UP/DOWN key 3 to 4 times slowly until garage
door opener operates.
PUTTING OPENER INTO PROGRAMMING MODE:
1. Press and hold the SET/PRGM button on the opener for
2-5 seconds.
• The ROUND LED will turn BLUE. Release button.
LONG
• The LED will then flash PURPLE.
2. Complete programming steps.
PRESS
&
RELEASE
Solid Blue
NOTE: The openers LEARN LED will time out in 30 seconds.
Programming must be completed within 30 seconds.
22
to begin programming.
TAB
Flashing Purple
(ABBREVIATED)
STEP 3) OPERATING THE KEYPAD WITH THE OPENER
Single Door Operation:
1. Ensure number pad back lighting is off.
2. Enter PIN number.
3. Press the UP/DOWN key.
4. Opener will operate.
NOTE: Keypad will remain active for 15 seconds after a
successful entry is made. During this 15 seconds ANY key will
operate the opener.
Resetting a PIN:
Press and hold both the PROGRAM key and the Up/Down key
for about five seconds.
The LED's will slowly blink and then go out. When the LED stops
blinking, the old programming has been successfully erased.
To create a new PIN go to STEP 1-Programming a PIN number.
Mounting Keypad
The keypad MUST be mounted within sight of the garage door(s) at
least five feet above the floor and clear of any moving door part.
1. Remove battery cover and batteries.
2. Drill 3/32" pilot hole for the top mounting screw (includ-
ed).
3. Install a screw into the pilot hole, leaving a 1/8" gap be-
tween the screw head and wall.
4. Hook the slotted mount, on back of keypad, over the
screw.
5. Mark and drill a pilot hole for the bottom screw (included)
and secure keypad to wall (DO NOT overtighten).
6. Reinstall batteries and cover.