Adding A Remote Device - Huawei OceanStor 2000 V3 Series Features Manual

OceanStor V3 Series
HyperMetro Feature Guide for Block
1.
2.
----End
Follow-up Procedure
If a suitable HyperMetro license is unavailable, apply for and import a license file as
instructed in the Installation Guide of the corresponding product model.

4.6.2 Adding a Remote Device

This operation enables you to establish a logical connection between a local storage device
and a remote storage device for data transfer between the two devices.
Prerequisites
l
l
Context
This operation is only performed on the local storage system.
The link between a local storage device and a remote storage device can be a Fibre Channel
link or an iSCSI link.
Procedure
Step 1 Log in to DeviceManager.
Step 2 Choose
Step 3 Click Add Remote Device.
The Add Remote Device Wizard dialog box is displayed.
Step 4 Set up the connection to the remote device.
Issue 05 (2018-01-30)
In the navigation tree on the left, choose Active License.
In the middle information pane, verify the information about active license files.
A local storage device is normally connected to a remote storage device.
To add remote devices when firewalls are configured, enable ports 36061 and 3260.
NOTE
l On a Fibre Channel network, clear zone configurations of ports connecting to the storage system
from the switch before adding the remote device. You are advised to allocate two ports in one zone
to prevent excessive remote links because too many ports exist in one zone.
l
A maximum of eight available links can be identified between a controller and the remote device,
and at most eight of these links can be used for replication when you add a remote device.
Data Protection >
NOTE
When a large number of remote storage devices exist, you can select desired remote devices through
their WWNs. Click Home on DeviceManager. In the Basic Information area, you can view WWN.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
HyperMetro.
4 Configuration
76