Huawei OceanStor 2000 V3 Series Features Manual page 71

OceanStor V3 Series
HyperMetro Feature Guide for Block
Before the configuration, make sure that the quorum server has been configured with service
IP address and firewall.
1.
Issue 05 (2018-01-30)
Configure a service IP address for the quorum server.
NOTE
If two ports of the quorum server are not bonded, IP addresses of the two ports must be from different
network segments. If the two ports of the quorum server are bonded, you only need to configure a
virtual IP address for arbitration.
– When deploying the arbitration software using VMs, you need to create virtual
network adapters and switches for VMs. In this example, arbitration software is
deployed on VMs, and two ports of the quorum server are not bonded.
and Table 4-4 show configuration requirements.
Figure 4-3 Configuration requirements of virtual network adapters
Table 4-4 Configuration requirements of virtual network adapters
Name Configuration
Requirement
Networ vmnic0 connects to
k controller A of the local
adapter and remote storage
2 systems in the HyperMetro
pair.
Networ vmnic1 connects to
k controller B of the local
adapter and remote storage
3 systems in the HyperMetro
pair.
– When deploying the arbitration software using physical machines, the two ports of
the quorum server are not bonded and you are advised to configure service IP
addresses at two different network segments for arbitration ports. In this example,
arbitration software is deployed on physical machines, and two ports of the quorum
server are not bonded.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Example
Switch name: vSwitch 1
n
Physical adapters name: vmnic0
n
Physical adapters IP addresses and
n
mask: 192.168.6.31/255.255.255.0
Switch name: vSwitch 2
n
Physical adapters name: vmnic1
n
Physical adapters IP addresses and
n
mask: 192.168.7.31/255.255.255.0
Table 4-5 lists configuration examples.
4 Configuration
Figure 4-3
63