Rs232 - Future Automation HQA2 Installation Instructions Manual

Mechanism Control

RS232

This Mechanism can be controlled via RS232, utilising a 6 Pin RJ11/RJ25 connector OR 9 Pin Serial connector
attached to a length of 6 core cable.
The mechanism's functions can be controlled by plugging this into the RJ11/RJ25 port on the mechanism control
box, then inputting the RS232 commands shown in the RS232 Input Table below.
Confirmation of Contact Closure input will be shown by a single flash of the large green LED located on the end
of the control box.
RJ11/RJ25 Pin Layout
PIN 1: RX
PIN 6: TX
PIN 3 & 4: GROUND
RS232 Programming Details
Baud Rate: 9600
Stop Bit: 1
Parity: None
Databits: 8
RS232 Input Table
IMPORTANT - Ensure all protocols are entered exactly as written below, including Carriage Return (ENTER / ASCII 13)
fa_in Carriage Return (Enter / ASCII 13)
fa_out Carriage Return (Enter / ASCII 13)
fa_right Carriage Return (Enter / ASCII 13)
fa_left Carriage Return (Enter / ASCII 13)
fa_preset Carriage Return (Enter / ASCII 13)
fa_a Carriage Return (Enter / ASCII 13)
fa_b Carriage Return (Enter / ASCII 13)
fa_c Carriage Return (Enter / ASCII 13)
fa_stop Carriage Return (Enter / ASCII 13)
fa_home Carriage Return (Enter / ASCII 13)
Page 18 of 20 // Installation Instructions - HQA2 Two Way Articulated TV Wall Mount 80"-110"
Protocol
Serial Pin Layout
PIN 2: RX
PIN 3: TX
PIN 5: GROUND
RJ11/RJ25 Func.
PIN 1 TX-RX
PIN 3 GROUND
PIN 4 GROUND
PIN 6 RX-TX
Device OUT with NO SWIVEL
Device OUT RIGHT limit
Device OUT LEFT limit
Device to PRESET memory position
Device OUT to memory position A
Device OUT to memory position B
Device OUT to memory position C
Device STOP (At any position)
Device OUT swivel parallel
9 PIN Serial Colour
PIN 2
PIN 5 Green
PIN 5
PIN 3
Action
Device IN
Blue
Red
White