Selecting Bite Registration - Planmeca Chairside PlanScan User Manual

15 SCANNING

15.9 Selecting bite registration

54 Planmeca Chairside CAD/CAM solution
7. Re-click the tool to deactivate it.
The model is smoothed where the data has been erased.
8. Activate the scanner.
9. Begin scanning with the occlusal of one of the adjacent
teeth. Once you have established where you are, you can
begin to scan the bite registration data.
10.Scan the occlusal of the bite registration material and any
of the adjacent tooth data that was removed and is not
covered by the bite registration.
Highlight the opposing dentition to designate which areas
of this model should be used for occlusion.
1. Click Bite Selection at the bottom of the screen. This icon
only appears on the Scan Bite screen.
2. Click and drag to highlight the areas of the opposing
dentition that would come into contact with the restoration.
3. Click Bite Selection again to deactivate it.
NOTE
If you made a mistake and need to start over click Reset.
User's manual