Control Techniques Commander SE Series User Manual page 60

• Press the
rd
3. If the Drive trips during these tests the display will show, for example
tr
The right hand display will flash with the trip code
4. Press the
run the Drive.
5. The
= On.
If this test has been carried out as a bench test and the Drive is to be
NOTE
connected to a different motor with different characteristics etc. in the
application, then the motor map parameters should be set to the correct
values for the new motor and another autotune carried out (see parameter 38
for details).
56
STOP key to STOP the Drive. The display should show:
0.0
OU
RESET button to reset the trip. Press the
FORWARD/REVERSE button can be enabled by setting parameter 26
RUN button to
Commander SE User Guide
Issue Number 5